Description

CHARACTERISTICS

Fine gypsum-based finishing mortar designed for manual interior application. The formula contains special additives that ensure very good workability, high adhesion and a smooth, uniform final surface, with reduced material consumption.

• Suitable for interior walls and ceilings in areas with normal humidity.
• Recommended for levelling and finishing mineral substrates.
• Can be used prior to painting, wallpapering or ceramic tile installation.
• Single-coat application.
• Fine texture and optimal working time (30–40 minutes).

MIXING INSTRUCTIONS

Mix with clean water until a smooth, lump-free paste is obtained. Mixing can be performed manually or mechanically at low speed.

Application

The substrate must be cleaned in advance from dust and impurities. Apply the material manually in an even layer using a steel trowel. Working time: approx. 30–40 minutes. Provides a fine, smooth surface ready for further finishing. Painting or wallpapering must be carried out only after complete drying, which may vary between 2 and 30 days depending on layer thickness, temperature and ventilation. Recommended layer thickness: 5–50 mm.

CURING CONDITIONS:

Curing occurs through gradual water evaporation. Ensure constant temperature and adequate ventilation, and avoid strong drafts. Full drying may take between 2 and 30 days, depending on layer thickness and environmental conditions

WORKING TEMPERATURE:

+5°C to +30°C (for substrate, material and ambient temperature).

CONSUMPTION

Approx. 0.9–1.1 kg/m² for each 1 mm of layer thickness.

Storage

Store in dry, covered areas, protected from moisture, on pallets, in the original sealed

SHELF LIFE:

12 months from the date of manufacture, in the original 20 kg packaging